⚠️Due to constant version iterations, the actual accessories (such as protective foam, the through pin, tools, etc.) in the box might be slightly different from those shown in the unboxing video or the pictures in the article. Please refer to the actual package received.
Follow the steps below to properly unpack and install your new MagicJimmy Spark AI 3D printer.
VIDEOMagicJimmy Spark AI Quick Start Video Guide
16 Steps · Unboxing → Power On
1📷 Step 1
Open the box.
2📷 Step 2
Take out the foam and accessories. Lift the printer out of the box.
3📷 Step 3
Check the accessories: an MagicJimmy Spark AI 3D printer, a Quick Guide, a spool of 200g filament, 2 sheets of DIY stickers, a pair of pliers, a spool holder, a calibration card, a magnetic base plate, etc.
4📷 Step 4
Open the printer's door, and take out the protective foam and the power adapter, which is inside of the foam.
5📷 Step 5
Cut and remove the strap around the print head.
6📷 Step 6
Pull out the bed.
7📷 Step 7
Place the base plate along the edge of the bed.
8📷 Step 8
Install the spool holder at the back of the printer.
9📷 Step 9
Unhook the filament from the spool and place the spool onto the holder. Ensure the tip of the filament is facing upward.
10📷 Step 10
Press the extruder cover slightly and remove it.
11📷 Step 11
Cut the tip of the filament at an angle.
12📷 Step 12
Straighten the tip.
13📷 Step 13
Push the spring up and hold it, then insert the tip and feed it into the tube.
14📷 Step 14
Replace the cover.
15📷 Step 15
Take out the adapter.
16📷 Step 16
Connect the power cable to the printer.
📧If you have any further questions, please contact service@magicjimmy.com for assistance.